A couple years ago the OBD1 codes were also posted in this thread. I noticed a good while back that someone had removed them.
The link in the first post used to have them listed, but it does not want to load for me.
Does anyone have the OBD1 codes (pre-96) that they could post?
Thanks,
*** On edit, I found them;
OBD1 Code Definitions
11 Transaxle codes present
12 Diagnostic check only
13 Oxygen sensor circuit
14 Coolant sensor/high temperature
15 Coolant sensor/low temperature
17 PCM fault - pull-up resistor
19 6X signal fault (92-95 models)
21 Throttle position sensor-voltage high
22 Throttle position sensor-voltage low
23 IAT circuit low
24 VSS circuit-no signal
25 IAT circuit-Temp out of high range
26 Quad driver output fault
32 EGR system fault
33 MAP sensor - voltage out of range high
34 MAP sensor - voltage out of range low
35 IAC - rpm out of range
41 Ignition control circuit-open or shorted
42 Bypass circuit - shorted or open
41/42 IC control circuit grounded/bypass open
43 Knock sensor circuit shorted or open
44 O2 sensor indicates lean condition
45 O2 sensor indicates rich condition
46 Power steeringpressure circit(91 models)open or shorted
49 High idle indicates vacuum leak
51 PCM memory error
53 System voltage error
55 A/D error
58 trans fluid temperature too high
59 Trans fluid temperature too low
66/67 A/C pressure sensor
81 ABS message fault
82 PCM internal communication fault
__________________
2002 SC2 31k 5spd Red / Gray leather
1999 SW2 105k Auto Brown / Tan leather
1998 SC2 106k 5spd(sold) White / Gray leather
1995 SL2 190k 5spd, (sold) Plumb
1993 SC2 121k 5spd, Red / Tan leather | 
Linear Mode
