Saturn Spot
 

 


Go Back   Saturn Spot > Saturn Model & Technical Discussion > How Do You Fix This?


Reply
 
LinkBack Thread Tools Display Modes
Old 03-11-2005, 04:01 AM   #1
Senior Member
 
Join Date: Nov 2003
Location: Baltimore, MD
Posts: 1,931
Default Customizing Your Tail Lights


Submitted by: micah_sl2

Introduction


Nobody manufactures custom tail lights for the Saturn S-Series, however, there are many ways to customize your factory Saturn tail lights:






Redding Out

This makes the rear turn signal red instead of amber.

1. Remove your tail lights. (91-95 SLx - 3 Torx Screws)
2. Wash with dish soap.
3. Sand orange portion (or entire tail light if you want to) with 600 grit wet sandpaper.
4. Wash tail lights again.
5. Mask off any portion that you do not want to paint (reverse lights)
6. Spray Red Anodized Look Paint (Wal-Mart or Auto Parts Store) or Candy Apple Red Paint (Hobby Store) in thin coats, follow the directions on the can.
7. Sand with 800 grit wet sandpaper between each coat.
8. Spray clear coat for protection, or have tail lights professionally clear coated for best results.






Tinting

Follow same steps as redding out, but use VHT Niteshades (eBay, Summit Racing). Do not tint reverse lights because it will reduce night time visibility when backing up.

To remove raised lettering, use a flat razorblade.

http://memimage.cardomain.net/member...1_182_full.jpg
http://memimage.cardomain.net/member...1_183_full.jpg
http://memimage.cardomain.net/member...1_184_full.jpg
http://memimage.cardomain.net/member...1_205_full.jpg






Rewiring (Based on 1st Gen SLx)

*Do Not Change Any of the Ground Wires

The rear lights are positively switched.

I chose to use the thin strip on the bottom of the tail light as the parking lights and turn signals (after redding out). The upper portion remains the brake light only. I wired the small 194 bulb in the corner to blink with the turn signal.

The original turn signal bulb is a single filament, so it can only serve one function. I took a dual filament socket and shaved the tail light housing with a rotary tool so it would fit in the 1157 bulb hole.

Colors:

Brake: blue
Parking: brown
Turn Signal: yellow






Custom Paint

I took my tail lights to the local body shop with a design that I drew, and had them color match the tail lights to my car.

http://memimage.cardomain.net/member...1_235_full.jpg
http://memimage.cardomain.net/member...1_236_full.jpg[/b]

Agilab is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT. The time now is 12:51 AM.

© 2006 - 2008 Saturnspot Forums | Legal | A member of the Crowdgather Forum Community

 

Powered by vBulletin® Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0