Rear-Vue

hey,


i was just wondering if their a smart way to un assemble the headlight assembly i wanna clean it up i got into a car accident and ost of you know and i got a brand spanking new one and its crystal clear.. and the other one looks dirty and foggy.. so i was gonna go nuts with windex. and clean it but dont wanna just jump into it and start talking it apart want some knowledge before i do.

thanks.

__________________
Rear-Vue is coming look behind you.

http://www.cardomain.com/id/sattyinsnow

"You may have a NATION behind you but we have a PLANET behind us" *stolen with pride by rear-vue

"sex should be like driving a honda slow, and loud enough to annoy the neighbours"

sc2_ct

Start by using some Mother's Mag and Aluminum polish and do small circles all over the outside of the old lens. Once it hazes, buff it off and do it again. After 2-3 times, use a little plexy polish just to brighten it up with a single pass. Your headlights will look pretty much new, no disassembly required.

__________________
http://www.domesticracingconcepts.com
http://www.cardomain.com/id/sc2_ct

And before you ask, the bodykit is from:

http://www.saturnmotorsports.com

CelticShadow

You could always try Meguiars Clear PlastX. That stuff works wonders!

__________________
Mike Hoffman
StreetStylez.org Owner
SPOC-National President

tristanlee85

If you do need to disassemble them, put them in the oven for about 15 minutes at 350 degrees, May sure you remove the level on the headlights if your year/model has one. That plastic on the level isn't as strong as the headlight itself. After 15 mins, take it out, sit it on a towel, have gloves on because the light will be hot. Use abutter knife if you have one, and gently pry the plastic away from the headlight backing. You will need to pry, reheat, pry, reheat, etc until it eventually comes off.

__________________
www.PlastikRacing.net
Saturn Performance Products