Saturn Spot
 

 


Go Back   Saturn Spot > Saturn Model & Technical Discussion > Saturn S-Series


Reply
 
Thread Tools Display Modes
Old 05-14-2016, 08:24 PM   #1
krajef
Junior Member
 
Join Date: Apr 2016
Posts: 7
Default 2002 SL2 lost reverse and slow to shift from 1 to 2.


Hi

Problem started today. I noticed that on acceleration when my car shifted from first to second gear (automatic 167K miles) there was a lag and this is now consistent. Shifting from 2nd gear up is fine.

Got a little worse. On takeoff when shifting from 1st to 2nd gear, the lag is there and a sound of a slipping metal to metal contact. Then I got a SES P0732 code.

During the above affects, reverse was not kicking in until I gave it some gas. After a couple of hours, reverse no longer engages. I'm now parking where I can pull straight out.

Checked the transmission fluid, was a wee under level so I put in about 1/3 quart. Looks clean, pink don't stink. I bought the car last May 2015.

Before I start looking for another set of cheap wheels, any suggestions? I'm hoping maybe easy to replace servos or something.

Thanks
Jeff

krajef is offline   Reply With Quote
Old 05-15-2016, 04:27 AM   #2
derfderf
Senior Member
 
derfderf's Avatar
 
Join Date: Nov 2006
Location: Out on the Tiles
Posts: 624
Default

P0732 usually means input shaft nut has worked loose.

Remedy--replace input shaft nut with new one and torque to spec (impt)

Other shifting issues are usually the result of bad solenoids in the transmission's valve body.

Both can be accessed, diagnosed and repaired/replaced without disassembly of the transmission.

There are numerous posts all over multiple Saturn forums explaining how to access, test, and replace what's needed.

Pretty much EVERY S series Auto Tranny, if it lives long enough, will experience exactly these symptoms. Just a matter of when

Rebuilt valvebodies can be had for reasonable $$ on ebay.
__________________
derf/PA
97 SC2 ~253K

95 SC2 ~235K +/running-- "All in the Family"
derfderf is offline   Reply With Quote
Old 05-22-2016, 01:14 AM   #3
krajef
Junior Member
 
Join Date: Apr 2016
Posts: 7
Default

Just a followup. Yesterday I pulled the transmission cover and my input shaft nut was loose as a goose. I was able to spin it off by hand only. Cleaned / sponged up the tranny fluid put on some locktite reinstalled the nut all is fine now!

Just a note. I decided to knock out my ball joint because i just got my car aligned.

Also I pulled out the two subframe bolts and the tranny dropped a couple more inches which gave me plenty of room.

Started at 5pm was done by 7:30. Was pretty easy job.

Thanks for the advice!
krajef is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 04:25 AM.

© 2006 - 2016 CrowdGather | Advertisers | Investors | Legal | A member of the Crowdgather Forum Community

 

Powered by vBulletin® Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.